Hytera RD98X series - Page 119

Hytera DMR System Planner
115
 Transmitting
Set the TX frequency.
Set TX CTCSS/CDCSS type.
Set CTCSS.
Set CDCSS code
Mixed channel setting:
 Channel Spacing
Configure the bandwidth of the TX frequency and RX frequency.
 Carrier Squelch Level
For better communications, you can set the squelch level of the repeater.
 Color Code
Set whether the CTCSS/CDCSS table is applied during decoding.
 Type of PTT TX Channel
Set the channel for transmitting audio.
 Pre-emphasis
Set whether the audio would be pre-emphasized.
 Scrambler
Set whether the signal will be encrypted.
 Flat Audio
Set the way of the output of the audio signal from the accessory pin.
 Receiving
Set RX frequency
Set CTCSS/CDCSS type.
Set CTCSS.
Set CDCSS code
 Transmitting
Set the TX frequency.
Set TX CTCSS/CDCSS type.
Set CTCSS.