Hytera TETRA PT580H - Attaching the Belt Clip; Attaching the Audio Accessory;Programming Cable; Status Indication; LCD Icon

6
■ Attaching the Belt Clip
Remove the two screws as shown in the gure below.
Align the screw holes on the belt clip with those on the
terminal’s body, and then tighten the screws, as shown in the
gure below.
To remove the belt clip, loosen the screws.
■ Attaching the Audio Accessory/Programming
Cable
Loosen the screw on accessory jack cover, and open the
cover as the arrow shows.
Align the plug with the accessory jack.
Tighten the screw on the plug.
To remove the accessory, loosen the screw.
1.
2.
1.
2.
3.
Status Indication
LCD Icon
Icon Name Icon Terminal Status
Battery Strength
Icons
Low battery
More bars indicate more
battery power
RSSI
No signal
More bars indicate better
signal strength
Message Icons
Unread message
Inbox is full of unread
messages
Operation Mode
Icons
The terminal currently
operates in TMO mode
The terminal currently
operates in DMO mode
Prole Icons
Silent
Normal (Ring and vibration
are enabled)
Vibration only
Accessory Icon
An audio accessory is
connected
Call Icon A call is in progress
Talkgroup
Selection Icon
Talkgroup selection is in
progress.
Before Use
PT580H Hytera 英文说明书 00(RoHS).ind6 6 2010-12-8 17:26:50