Hytorc jGun J-25 User Manual

TABLE OF CONTENTS (CONTINUED)
HYTORC Washer Overview 41
Safety 42
Personal Protective Equipment 42
HYTORC Washer Requirements 43
HYTORC Washer Assembly, Use and Service (SETUP) 43
Important Preparation Steps for the HYTORC Washer 43
Important Installation Procedures 44
Tightening with the HYTORC Washer 46
jGun Maintenance and Troubleshooting Tips 46
Changelog 46
Figures 21
Figure 1. Reaction Arm 21
Figure 2. HYTORC Washer and Driver 21
Figure 3. Installing a Reaction Arm 22
Figure 4. Reaction Arm Installed 23
Figure 5. Tightening Reaction Arm Set Screw 23
Figure 6. Installing jGun Socket 24
Figure 7. Installing Socket Locking Pin and Retaining Ring 24
Figure 8. Placement of Reaction Arm 25
Figure 9. jGun Drive Direction Lever 27
Figure 10. jGun Operation 28
Figure 11. Using the jGun with a HYTORC Washer 29
Figure 12. jGun® DUAL SPEED 31
Figure 13. High Speed Setting (Left) and Maximum Torque Setting (Right) 32
Figure 14. FRL Unit (Shown without silencer) 34
Figure 15. Emptying the FRL Filter Reservoir 37
Figure 16. Detaching FRL Reservoir 37
Figure 17. FRL Unit – Lubricator 2/3 Full of Oil 38
Figure 18. Adjusting FRL Regulator 39
Figure 19. Adjusting FRL Oil Flow 40
Figure 20. Static Dissipative Hose 41
Figure 21. HYTORC Washer and Driver 41
Figure 22. HYTORC Washer Socket Mounted on jGun 42
Figure 23. HYTORC Washer Installed 44
Figure 24. Aligning HYTORC Washer Socket Set Screw with Machined Recess in jGun Splines 45
Figure 25. Tightening HYTORC Washer Set Screw 45
TABLES 26
Table 1: Bolt Torque Specications 26

Hytorc jGun J-25 Specifications

General

Brand	Hytorc
Model	jGun J-25
Category	Power Tool
Language	English