Warranty
The jGun has a one year limited warranty. Every HYTORC tool is tested before leaving the factory and is
warranted to be free from defects in workmanship and materials. HYTORC will repair or replace, without
charge, any tool which upon examination proves to be defective in workmanship or materials for one (1)
year after the date of purchase. This warranty does not cover damage from repairs made or attempted by
other than HYTORC authorized repair facilities.
The repair and replacement remedies described herein are exclusive. In no event shall HYTORC be liable
for any incidental, special, or consequential damages, including loss of prots. This warranty is exclusive
and in lieu of all other warranties or conditions, written or oral, expressed or implied for merchantability or
tness for particular use or purpose.
This warranty gives you specic legal rights. You may also have other rights that vary from state to state
and province to province. In those states that do not allow the exclusion of implied warranties or limitation
of incidental or consequential damages, the above limitations or exclusions may not apply to you.
If you have questions about the HYTORC warranty, contact our customer service center at 201-828-5270.
HYTORC
120 Wesley Street, Hackensack, New Jersey 07606 U.S.A.
Tel: 201-828-5270 • E-Mail: info@hytorc.com • Web: www.hytorc.com
6
jGun Overview
The jGun pneumatic torque wrench is designed to safely and accurately deliver up to 8,000 ft-lbs of
torque onto a fastener. This is accomplished using a patented planetary gearbox torque multiplier
system and an appropriate reaction arm or HYTORC Reaction Washer™ and HYTORC Nut™. The
torque multiplier produces torque ratios of up to 1450:1 while the reaction arm or washer is used to
absorb the high counter rotational force produced as the nal torque value is reached. At nal torque
value, the jGun safely stalls out, leaving the fastener tightened to specication.
Unlike impact wrenches, the jGun never transmits working torque to the operator. The torque is applied
between the fastener and the reaction surface.
This manual provides information for both the standard jGun® SINGLE SPEED and the jGun® DUAL
SPEED.
To Next Page
Loading...
Need help?
General
