Hytorc LITHIUM II Series - Charge, Test, and Install Battery; Battery Charging Procedures; Charging and Fault Indicator Guide; Battery Storage Guidelines

Install Reaction Arm (Conventional Torque)
Caution: Never modify a reaction arm!
Changes in the reaction arm may lead to
personal injury or damage to the Tool.
Flat on Reaction Spline
Allen Set Screw
 Reaction arm used only for conventional bolting applications.
 Slide the reaction arm over the drive spline while aligning the
Allen Set Screw with the flat on the Reaction Spline.
 Tighten Allen Set Screw to firmly attach the reaction arm to
the spline.
 Challenge the reaction arm to make sure it is firmly secured.
L3
Tighten Screw