Hytorc LITHIUM II Series - Conventional Torque Setup; Conventional Torque Tightening

Advanced Bolting Features
L11
 Turn Angle: used to complete Turn-Of-Nut procedures by turning a
snug-tightened nut through specified angle.
 Torque Check: used to determine whether a previously tightened
nut still meets specification.
• Typically, the user sets Torque Check to 90% of the specification value,
pulls the trigger and monitors the nut to detect any movement.
• When job data is exported, the profile type for Torque Check is “TCK”.
 Rotations: turns a fastener through a specific number of rotations.
• Tool will turn nut and stop at the specified number of Rotations.
• Continue holding trigger if applying angle or release.
• The maximum capacity of the rotations feature is 99.9 rotations.