Hytorc LITHIUM Series User Manual


The Snug function is used to bring two bolting surfaces into alignment and contact. It may also be used to tighten bolts at
a lower torque. In structural bolting, the snug operation is applied first to bring surfaces into contact followed by either a
calibrated torque or “Turn-of-Nut” (Turn Angle) method to fully tighten the fastener to specification.
The Snug function may be selected from the Main Menu or may be displayed when the user scrolls below the lowest
calibrated value on the Torque screen. When the user enters Snug through the Main Menu, the minimum Snug value
is displayed. The user can adjust the value using the left and right buttons to the nearest ft-lb (or alternate unit). Angle
may be used with Snug by adjusting the value via the Angle menu option. The user can adjust Release angle as needed
to release the tool from the application. If the user requires more torque than provided by the Snug function they can
continue to push the left button to return to the Torque function.
The Snug range is defined from the minimum reliable output of the tool to the minimum calibrated value for the tool.
When the tool is operating in the Snug range, the accuracy is less than in the calibrated range as defined in the
documentation for each tool. The Snug value will be retained in the tool until it is changed.
SNUG
(CONT’D.)(CONT’D.)

Hytorc LITHIUM Series Specifications

General

Brand	Hytorc
Model	LITHIUM Series
Category	Tools
Language	English