Convenience Features
5-64
High beam operation
2C_HighBeamOn
To turn on the high beam headlight, push
the lever away from you. The lever returns
to its original position.
The high beam indicator lights when the
headlight high beams are switched on.
To turn off the high beam headlight, pull
the lever towards you. The low beams
turns on.
WARNING
Do not use high beam when there are
other vehicles approaching you. Using
high beam could obstruct the other
driver’s vision.
2C_HighBeamFlash
To flash the high beam headlight, pull the
lever towards you, then release the lever.
The high beams remains ON as long as
you hold the lever towards you.
Turn signals and lane change
signals
2C_TurnSignalSwitch
To signal a turn, push down on the lever
for a left turn or up for a right turn in
position (A).
If an indicator stays on and does not flash
or if it flashes abnormally, one of the turn
signal bulbs may be burned out and may
require replacement.
One touch turn signal
To use One Touch Turn Signal push the
turn signal lever up or down to position
(B) and then release it.
The lane change signals blink 3, 5 or 7
times.
You can enable the One Touch Turn
Signal function or choose the number of
blinking by selecting Settings > Vehicle >
Lights > One touch turn indicator > 7
flashes/5 flashes/3 flashes/Off in the
infotainment system.
0SX2HEV_en_GN.book Page 64
To Next Page
Loading...
Need help?
General
