IAE DraftMaster - Sliding Door Installa on

9
Sliding Door Installaon
Step 2.
Aach the latch housing assemblies (at each end) to the sliding
door top channel using X2 M6 X 10 setscrews (supplied secured
to the latch housing assembly) as shown in Fig. 17 & 18
(LatchesÊtoÊbeÊfiedÊupÊmirroringÊeachÊother)Ê
TheÊinformaonÊinÊthisÊseconÊaimsÊtoÊprovideÊ
personnelÊwithÊadequateÊinstruconsÊtoÊbuildÊaÊ
RIGHT HANDEDÊDraMasterÊ
Step 1.
To begin, fit the stop plates through the holes in the inner
cage framework on the right hand side (at each end) using
M8 X 45 cup square bolt as shown in Fig. 15 & Fig. 16
(StopÊplatesÊtoÊbeÊfiedÊupÊmirroringÊeachÊother)
Fig 15
Fig 16
Fig 17
Fig 18
(ComponentsÊtransparentÊforÊ
clarityÊinÊFigÊ18)