IBA KermaX-plus 120-131 E - Page 6

iv | Table of Contents | KermaX-plus
®
Chamber
4.2.1. Installing the Chamber in the X-Ray Machine 25
4.2.2. Electrical Configuration of KermaX-plus
®
26
4.2.3. Electrical Configuration of KermaX-plus
®
with SDP 27
5. Measurement 29
6. Quality Assurance 31
6.1. System Test (Stability Check) 31
6.1.1. Test Value 31
6.1.2. Test Value discussion 31
6.2. Calibration Check 31
6.2.1. Measurement Setup 32
6.2.2. Calibration Check procedure 33
6.3. Test the drift of indicated values 34
6.3.1. Positive drift 34
6.3.2. Negative drift 34
6.4. Test tolerance and interval 34
6.5. Recalibration 35
6.6. Test Value Adjustment 36
7. Air Density Correction 37
7.1. Air Density Fluctuation in the Ionization Chamber 37
7.2. Correction Overview 37
8. Service and Technical Support 39
8.1. Warranty 39
8.1.1. Warranty, General 39
8.1.2. Warranty, Limitations 39
8.2. Maintenance of KermaX-plus
®
40
8.3. Cleaning and Disinfection 40
8.4. Troubleshooting 41
8.5. Safety Inspection 42
8.6. Disposal and Recycling 42
8.7. Technical Support 43
8.8. Reporting Complaints 43
8.9. Returning device for repairs 43
9. Technical Specifications 45
9.1. Specifications of KermaX-plus
®
45
9.2. Interface Specification 46
9.3. Environmental Conditions and Requirements 48
9.4. Dimensions and Weight 49