Installing the new gas valve
1.
Secure the new gas valve to the gas valve connector with the 4 bolts, ensuring that
the O-ring is in place.
2.
Attach the aluminum gas block to the new gas valve, ensuring that the O-ring is in
place.
If this O-ring is lost, it must be replaced with a factory supplied O-ring.
Tighten by hand the 4 gas inlet block screws plus an extra ½ turn in a criss-cross
pattern.
3. Connect the wires to the gas valve.
4. Open up the gas supply valve, and check for leaks.
5. Tune the gas valve.
Section: Service and maintenance
To Next Page
Loading...
