IBERITAL
Page 68 INSTALLATION AND OPERATION MANUAL
ENGLISH
- New Iberital machines: Press the I/O button and the display will show the boiler temperature
in ºC, the time and the name entered.
xxxºC hh:mm
User MENU display: When the coee machine switch is in position 2 and the display in the ON position (on the
screen the name entered will be shown), press the MENU or TWO COFFEES button on the left button pad
(based on the display used) for at least 5 seconds, and enter the user level programming mode.
Technical MENU display: When the coee machine switch is in position 2 and the display in the OFF position (on
the screen the word OFF will be shown), press the MENU or TWO COFFEES button on the left button pad (based
on the display used) for at least 10 seconds, and enter the technical level programming mode.
IMPORTANT: Once inside the MENU, pressing on the MENU or NON-STOP button on the left button
pad (based on the display used) allows you to move through the display functions. Pressing the OK or TWO
ESPRESSOS button (based on the display used) will confirm the chosen function and confirm the changes.
To change between two functions, the UP or ONE ESPRESSO button moves you up an option, and the DOWN
or ONE COFFEE button (based on the display used) will drop you down an option. (See image in sections 2.9.1.1
and2.9.1.2.)
2.9.3.1.1 User menu display
- Programming the TIME and weekly ON/OFF for the machine:
When the words SET CLOCK appear, confirm the selection by pressing the OK button. The programming of the time
and day of the week is very important, because this information will be used by the control unit for the weekly ON/OFF
activation of the machine.
Set Clock
HH.MM.xxxxxxx
Press the UP/DOWN buttons to change the HOURS and press OK to confirm and move on to the MINUTES and the
day of the week. After confirming the day of the week, it will automatically go into the weekly ON/OFF programming
mode.
Auto On/Off
AAA:hh.mm
Pressing the UP/DOWN buttons will vary the HOURS until the desired hour is found, and then you must press the
OK button to confirm the selection and move on to the option of MINUTES (mm), carrying out the same operation
when the word OFF appears and the rest day.
IMPORTANT: So that the machine does not come on automatically, enter (--) hyphens in the selection of HOURS
(hh.mm) for ON and OFF and the rest day.
- Visualization of the counters:
Counters
In this section all consumption levels may be read.
- Press the OK button and the display will show:
HH: Hours
MM: Minutes
xxxxxxx: Day of the week
AAA: ON
OFF
hh: On/off hours
mm: On/off minutes
To Next Page
Loading...
Need help?
General
