Iberital EXPRESSION PRO - Page 70

IBERITAL
Page 70 INSTALLATION AND OPERATION MANUAL
ENGLISH
- The first option which appears is:
Language
xxxxxx
Where you can select the language (English, French, German, Spanish) via the UP/DOWN buttons. Once the desired
language has been selected, press the MENU button and move on to the following option:
Temp/time vis.
ENABLED/DISABLED
The display will give you the option of showing the rest position of the machine, the TIME and the TEMPERATURE
on the top line of the display.
Using the UP/DOWN buttons, select ‘ENABLED’ or ‘DISABLED’ from this option.
- If ‘ENABLED’ is selected, press the MENU button to move on to the following option:
Name 2
xxxxxx
On the display, Name 2 (the bottom line on the display) will appear, with the cursor situated in position 1 (of the
16 characters on the line). With the UP/DOWN buttons, select the letter or number required (BLANKSPACE!“#$%&...).
Pressing OK confirms the character and the cursor advances to the following character.
Continue this process until all the characters on the line are completed.
Once this procedure is completed, press the MENU button to move on to the following option:
Line rotation 2
ENABLED/DISABLED
On the display the name on Line 2 will either move about or remain static; with the UP/DOWN buttons, select
‘ENABLED’ or ‘DISABLED’ and press the MENU button to move on to the following option:
- If ‘DISABLED‘ is selected, press the MENU button to move on to the following option:
Name 1
xxxxxx
The name appearing on Line 1 (upper) of the display can be programmed, with the cursor in position 1 (of the 16
characters on each line) and using the +/- keys to select the dierent letter or number (BLANK SPACE! “ # $ % &...).
On finding the desired character, press the OK button to confirm and move on to the following character. Continue
the process until all the characters are done.
Once this procedure is completed, press the MENU button to move on to the following option:
Line rotation 1
ENABLED/DISABLED
On the display the name on Line 1 will either move about or remain static; with the UP/DOWN buttons, select
‘ENABLED‘ or ‘DISABLED‘ and press the MENU button to move on to the following option:
Name 2
xxxxxx
The name appearing on Line 2 (lower) of the display can be programmed, with the cursor in position 1 (of the 16
characters on each line) and using the +/- keys to select the dierent letter or number (BLANK SPACE! “ # $ % &...).
On finding the desired character, press the OK button to confirm and move on to the following character. Continue
the process until all the characters are done.