To Next Page

To Previous Page

Table 9. DSA diagnostic messages (continued)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

v See Chapter 3, “Parts listing, System x3200 M2 Types 4367 and 4368,” on page 33 to determine which components are

customer replaceable units (CRU) and which components are field replaceable units (FRU).

v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained

service technician.

Message

number Component Test State Description Action

201-805-xxx Memory Memory Test Aborted Test canceled: the

memory controller

display/alter write

operation was not

completed.

1. Turn off and restart the system.

2. Run the test again.

3. Make sure that the BIOS code is at the

latest level. The installed firmware level

is shown in the DSA event log in the

Firmware/VPD section for this

component. For the latest level of

firmware, go to http://www.ibm.com/

support/docview.wss?uid=psg1

MIGR-4JTS2T and select your system

to display a matrix of available

firmware.

4. Run the test again.

5. If the problem remains, collect the data

from the DSA event log and send it to

IBM Service. For information about

contacting and sending data to IBM

Service, see http://www.ibm.com/

support/docview.wss?uid=psg1SERV-

CALL.

201-806-xxx Memory Memory Test Aborted Test canceled: the