To Next Page

To Previous Page

Table 9. DSA diagnostic messages (continued)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

v See Chapter 3, “Parts listing, System x3200 M2 Types 4367 and 4368,” on page 33 to determine which components are

customer replaceable units (CRU) and which components are field replaceable units (FRU).

v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained

service technician.

Message

number Component Test State Description Action

215-901-xxx Optical drive Self-Test Aborted Drive media is not

detected.

1. Insert a new CD or DVD into the drive

and wait for 15 seconds for the media

to be recognized.

2. Run the test again.

3. Check the drive cabling for loose or

broken connections at both ends or

damage to the cable. Replace the cable

if it is damaged.

4. Run the test again.

5. For additional troubleshooting

information, see the “Troubleshooting

CD and DVD drive issues” site at

http://www.ibm.com/support/

docview.wss?uid=psg1MIGR-41559.

6. Run the test again.

7. Replace the optical drive.

8. Run the test again.

9. If the problem remains, collect the data

from the DSA event log and send it to

IBM Service. For information about

contacting and sending data to IBM

Service, see http://www.ibm.com/

support/docview.wss?uid=psg1SERV-

CALL.

215-902-xxx Optical drive Self-Test Failed Read

miscompare.