Installing the lower bezel ....................55
Removing the upper bezel....................56
Installing the upper bezel ....................57
Removing an adapter .....................58
Installing an adapter ......................59
Removing and installing internal drives ...............61
Removing a hot-swap power supply ................72
Installing a hot-swap power supply ................74
Removing a memory module...................75
Installing a memory module ...................76
Removing and replacing Tier 2 CRUs ................77
Removing the battery .....................77
Installing the battery ......................77
Removing the rear system fan ..................79
Installing the rear system fan...................80
Removing the hard disk drive fan assembly .............81
Installing the hard disk drive fan assembly ..............83
Removing the simple-swap backplate ...............84
Installing the simple-swap backplate ................86
Removing the SAS/SATA hard disk drive backplane ..........87
Installing the SAS/SATA hard disk drive backplane ...........88
Removing the front-panel assembly ................89
Installing the front-panel assembly.................90
Removing the front USB connector assembly.............90
Removing the rear adapter retention bracket .............91
Installing the rear adapter retention bracket .............92
Removing the front adapter-retention bracket .............92
Installing the front adapter-retention bracket .............93
Installing the front USB connector assembly .............93
Removing the hot-swap power supply cage .............94
Installing the hot-swap power supply cage ..............95
Removing the mini-SAS/SATA controller...............96
Installing the SAS/SATA controller .................97
Removing the optional mini-PCI-X enablement card ..........97
Installing the optional mini-PCI-X enablement card ...........98
Removing the IBM ServeRAID-MR10i SAS/SATA controller .......99
Installing the IBM ServeRAID-MR10i SAS/SATA controller .......100
Removing an IBM Remote Supervisor Adapter II SlimLine .......102
Installing an IBM Remote Supervisor Adapter II SlimLine ........102
Removing and replacing FRUs ..................105
Removing a non-hot-swap power supply ..............105
Installing a non-hot-swap power supply ..............107
Removing the microprocessor and fan sink .............109
Installing a microprocessor and fan sink ..............111
Removing the system board ..................114
Installing the system board ...................116
Chapter 5. Diagnostics .....................121
Diagnostic tools ........................121
POST ............................121
POST beep codes ......................122
No-beep symptoms ......................124
Error logs .........................125
POST error codes ......................127
Checkout procedure ......................137
About the checkout procedure ..................137
iv System x3200 M2 Types 4367 and 4368: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General