22 Connect the printer cable to your printer. Make
sure the cable connector
is
pressed firmly into
your printer.
23 Push the spring retainers into the slots
on
the
edges
of
the cable connector.
24 Connect the ground wire.
• Remove the nut from the ground stud.
• Remove one of the two star washers.
• Place the ground wire
on
the stud.
• Install the star washer and nut
on
the ground
stud, and tighten the nut.
Retainer
Slots
Washer
Nut
IBM Color Printer
5-53
To Next Page
Loading...
