Customizing Your Monitor
8
For
(Rotation)
(Pincushion)
(Pin Balance)
(Keystone)
(Key Balance)
Using the GEOMETRY
On-
screen Display
The GEOMETRY settings allow you to adjust the shape and
orientation of the picture.
Once the
(Rotation) is adjusted, it will be stored in
memory for all input signals received. All other adjustments
will be stored in memory for the current input signal.
1 Press the button.
The MENU OSD appears.
2 Press the ./> buttons to select “
GEOMETRY” and
press the
button again.
The GEOMETRY OSD appears.
3 Press the ./> buttons to select the item you want to
adjust.
Select
(Rotation)
(Pincushion)
(Pin Balance)
(Keystone)
(Key Balance)
To
adjust the picture rotation
adjust the picture sides
adjust the picture side balance
adjust the picture width
adjust the picture shape balance
Press
/ . . . to rotate the picture clockwise
? . . . to rotate the picture counterclockwise
/ . . . to expand the picture sides
? . . . to contract the picture sides
/ . . . to expand the picture sides to the
right
? . . . to expand the picture sides to the left
/ . . . to increase the picture width at the
top
? . . . to decrease the picture width at the
top
/ . . . to move the top of the picture to
the right
? . . . to move the top of the picture to
the left
4 Press the ?// buttons to adjust the settings.
Press the
button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
9
EN
Customizing Your Monitor
Using the CONVERGENCE
On-
screen Display
The CONVERGENCE settings allow you to adjust the
quality of the picture by controlling the convergence.
The convergence refers to the alignment of the red, green,
and blue color signals.
If you see red or blue shadows around letters or lines, adjust
the convergence.
Once the setting is adjusted, it will be stored in memory for
all input signals received.
1 Press the button.
The MENU OSD appears.
2 Press the ./> buttons to select “
CONVERGENCE”
and press the
button again.
The CONVERGENCE OSD appears.
3 Press the ./> buttons to select the item you want to
adjust.
Select
(Horizontal Convergence)
(Vertical Convergence)
TOP
V CONVER TOP
BOT
V CONVER BOTTOM
To
adjust the horizontal convergence
adjust the vertical convergence
adjust the vertical convergence at the
top of the screen
adjust the vertical convergence at the
bottom of the screen
4 Press the ?// buttons to adjust the settings.
Press
/ . . . to shift red shadows to the right
and blue shadows to the left
? . . . to shift red shadows to the left
and blue shadows to the right
/ . . . to shift red shadows up and blue
shadows down
? . . . to shift red shadows down and
blue shadows up
/ . . . to shift red shadows up and
blue shadows down at the top of
the screen
? . . . to shift red shadows down and
blue shadows up at the top of
the screen
/ . . . to shift red shadows up and blue
shadows down at the bottom of
the screen
? . . . to shift red shadows down and
blue shadows up at the bottom
of the screen
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
For
(Horizontal Convergence)
(Vertical Convergence)
TOP
V CONVER TOP
BOT
V CONVER BOTTOM
To Next Page
Loading...
