EasyManuals Logo

IBM 74Y4064 Handbook

IBM 74Y4064
226 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
link aggregation and failover features of the adapter make it suitable for critical network applications that
require redundancy and high availability. Figure 79 on page 176 shows the FC EN0W adapter.
The ports default to auto negotiate the highest speed either at 10 Gb (10G BaseT), 1Gb (1000 BaseT), or
100 Mb (100 BaseT) full duplex. Each RJ45 port can be configured independent of the other port. Each
RJ45 port is connected with a 4-pair, CAT-6A cable, and is supported for distances of up to 100 meters.
The adapter provides the following features:
v The adapter is a PCIe2 NIC network convergence adapter.
v The 10 Gb RJ45 ports can function in the NIC mode.
v The adapter can be used as the host local area network (LAN) adapter.
v The adapter supports interrupt moderation to deliver increased performance while significantly
reducing processor utilization
v The adapter supports dual port operation in any PCIe3 or PCIe2 slot.
v The adapter supports auto-negotiation, full-duplex only.
v The adapter supports multiple media-access control (MAC) per interface.
v The adapter supports integrated media-access control (MAC) and physical layer (PHY).
v The adapter supports the following standards for the different ports and functions:
IEEE 802.3ae in the 10 GbE ports
802.3ab in the 1 GbE ports
Ether II and IEEE 802.3 for encapsulated frames
802.1p for setting up priority levels in tagged VLAN frames
802.1Q for VLAN tagging
802.3x for flow control
802.3ad for load-balancing and failover
IEEE 802.3ad and 802.3 for link aggregation
v The adapter provides message signal interrupts (MSI), MSI-X, and support of legacy pin interrupts.
v The adapter supports jumbo frames up to 9.6 KB.
v The adapter supports gigabit EtherChannel (GEC) with the existing software.
v The adapter supports TCP checksum offload transmission control protocol (TCP), user datagram
protocol (UDP), TCP segmentation Offload (TSO) for IPv4 and IPv6.
v Supports TCP segmentation or large send offload
v Supports EEPROM-SPI and single EEPROM
v Compliant with European Union Directive 2002/95/EC on the Restriction of the Use of Certain
Hazardous Substances in Electrical and Electronic Equipment
Managing PCIe adapters 175

Table of Contents

Other manuals for IBM 74Y4064

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM 74Y4064 and is the answer not in the manual?

IBM 74Y4064 Specifications

General IconGeneral
BrandIBM
Model74Y4064
CategoryAdapter
LanguageEnglish

Related product manuals