Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ from your hardware.
Removing a bezel
When working with some devices, such as the media tray and power modules,
you must first remove the top or bottom bezels to access the devices.
To remove either bezel, complete the following steps.
Release buttons
Release buttons
1. Press the blue release button on each end of the bezel.
2. Pull the bezel away from the BladeCenter unit.
Chapter 4. Removing and replacing BladeCenter components 31
To Next Page
Loading...
