Installing a blower module
To install a blower module, complete the following steps.
Handle (open)
Release button
Note: These instructions assume that the BladeCenter unit is connected to power.
1. Make sure that the handle on the blower module is in the open position.
2. Orient the blower module to the selected blower-module bay:
v For the upper bay, the handle must be on the right.
v For the lower bay, the handle must be on the left.
3. Slide the module into the bay until it stops; then, push the handle to the closed
position.
Chapter 4. Removing and replacing BladeCenter components 49
To Next Page
Loading...
