EasyManua.ls Logo

IBM Aptiva 2158 - Power Management; Power Supply; Internal Cabling; Modem

IBM Aptiva 2158
222 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Information 5
•
Noise canceling microphone (available on certain models)
Power Management
•
Compliant to ACPI and supports Display Power Management Signaling
(DPMS) monitor.
•
Software shutdown by Windows 98.
•
System enters standby mode if any of following conditions are met:
- Execute standby from Windows 98 Start menu
- Press system power button if it sets to act as standby function.
- System is idle and the standby timer set in the Windows 98 Power Man-
agement Property elapses.
Power Supply
•
PC-98 compatible 95W ATX power supply
•
Searchable high/low voltage selection
Internal Cabling
•
Two 40-pin ribbon cables for hard disk drive and CD/DVD-ROM drive.
•
One 34-pin ribbon cable for AT diskette drive.
•
One 4-pin (2-wire) cable for hard disk drive light-emitting diode (LED).
•
One 3-pin (3-wire) cable for power light-emitting diode (LED).
•
One 2-pin (2-wire) cable for power switch.
•
One 4-pin modem voice-in/speaker-out cable.
Modem
•
56.6 Kbps PCI modem adapter card with data/fax/voice or non-voice
features.
•
Telephone line-out (RJ-11) connector.
•
Telephone line-in (RJ-11) connector.
Monitor (Not included with some models)
•
Super Video Graphics Array (SVGA) monitor.
•
Compliant to VESA power saving mode.
•
Connector for a detachable grounded 3-wire power cord
•
1.8-m (5.8-ft.) attached signal cable
•
Auto-sensing power input for 100 Vac to 240 Vac

Table of Contents