• The status field of the disk unit to
be
removed shows Configured.
Are
all
these conditions true?
Yes
No
1
You
cannot use the Remove Units
from Configuration function.
Go
to step 2 of this procedure.
22 Perform the following:
a.
Return to the Display Disk Configura-
tion display.
b.
Select the Display disk configuration
capacity option.
Does
the
% Used field for the disk unit to
be
removed show
an
asterisk (*)?
No
Yes
You
cannot use the Remove Units
from Configuration function.
Go to step 2 of this procedure.
23
Return to the Work with Disk Units display.
24
Perform the following:
a.
On
the Work with Disk Units display,
select the Work with disk unit recovery
option.
b.
Select the Disk unit problem recovery
procedures option.
c.
Select the disk unit to analyze.
d.
Select the Analyze disk unit surface
option.
e.
Press the Enter key
to
analyze the disk
unit surface.
f.
Wait until the Analyze function is com-
plete.
Note: This takes several minutes.
Is
the number of sectors with errors zero?
Yes No
You
cannot use the Remove Units
from Configuration function.
Go to step 2 of this procedure.
25
Return to the Work with Disk Units display.
26
Perform the following:
2-10 AS/400 9402/9404 Models 2xx Repair and Parts
a.
On
the Work with Disk Units display,
select the Work with disk configuration
option.
b.
Select the Work with ASP configuration
option.
c.
Select the Remove units
from
config-
uration option.
d.
Select the disk unit to
be
removed.
Note: If the disk unit
is
not displayed,
go to step 2 of this procedure.
e.
If
the Confirm Continuation display
appears, press the Enter
key
to con-
tinue. Wait for the next display.
f.
If
there is enough storage
in
the ASP,
the Confirm Remove Disk Units display
appears.
If
there is not enough
storage,
an
error message display
appears.
Does any error message display appear?
No
Yes
Go
to step 2 of this procedure.
27
Press the Enter key to verify the Remove
Disk Units function.
The Remove Disk Units function takes
several minutes. When it is complete, a
message appears stating whether it was
successful.
Was the Remove Disk Units function suc-
cessful?
Yes No
~
Go
to step 2 of this procedure.
28
On
the Work with ASP Configuration
display, select the Display disk configura-
tion capacity option.
29
Press
F11
twice to display non-configured
units.
Is
the unit you removed shown as a non-
configured unit?
Yes
No
Go
to step 2 of this procedure.
30
Do
you want to exchange the disk unit
now?
To Next Page
Loading...
Need help?
General
