remove the DIMM, then reinsert it.
DIMM
connector 1
DIMM
connector 2
DIMM
connector 3
DIMM
connector 4
11. If you have other options to install or remove, do so now. Otherwise, rotate the
drive cage back into the computer and replace the support bracket (see
“Removing and installing the support bracket” on page 27); then, go to
“Completing the installation” on page 40.
Installing a security rope clip
To help prevent hardware theft, you can add a security rope clip and cable to your
computer. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
Before you begin, obtain the following items:
v A flat-blade screwdriver
v An adjustable wrench
v A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing
number 3230, stock number 176-735)
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices (see “Turning off the computer”
on page 43; then, disconnect all external cables and power cords.
2. Remove the cover (see “Removing the cover” on page 14.
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, make sure that it does not interfere with other
20 IBM IntelliStation M Pro Types 6220 and 6230: Installation Guide
To Next Page
Loading...
Need help?
General
