IBM IntelliStation M Pro - Running the Operating System Setup Program

Notes:
1. Turn on all external devices, such as the monitor, before turning on the
computer.
2. The power-on LED on the front of the computer is lit when the computer is on
and while it is being turned on.
Approximately 20 seconds after the computer is connected to ac power, the
power-control button becomes active, and you can turn on the computer and start
the operating system by pressing the power-control button. The computer can also
be turned on any of the following ways:
v If a power failure occurs while the computer is turned on, the computer will
restart automatically when power is restored.
v When you connect your computer to power for the first time, the Wake on LAN
®
feature can turn on the computer. If your computer was previously turned on, it
must be properly turned off for the Wake on LAN feature to turn on the computer.
Running the operating system setup program
If you are starting your computer for the first time, the setup program runs
automatically when you start the computer. The program will prompt you to make
choices or type information. If you need more detailed information other than what
is provided in this Installation Guide, see your operating-system manual.
Important:
1. After turning on your computer for the first time, you must complete the
operating system setup procedure before turning off your computer; otherwise,
unexpected results might occur.
2. The setup program might be slightly different from the one described in your
operating-system manual. Some choices do not appear because they are
preset.
3. During the setup procedure, you must indicate that you accept the license
agreement.
4. For Windows operating systems, the registration information will already be
displayed in the registration field. If the Product ID number is not already
displayed, you must type it. The Product ID is on a label attached to the
computer.
You will need the following information to complete the setup program in Windows
operating systems:
v The documentation that comes with your computer.
v Network information from your network administrator, if your computer is being
connected to a network.
v The printer model and port, if a printer is attached directly to your computer.
After the setup procedure is completed and the computer restarts, the desktop
opens. Your computer is ready for use.
42 IBM IntelliStation M Pro Types 6220 and 6230: Installation Guide