To Next Page

To Previous Page

#E.4.1 Installing the Hot Key Program for DOS

#To install this program, follow the steps below.

$1. Insert the backup copy of the Reference Diskette into the diskette

$ drive.

$2. At the DOS prompt (usually C:\>), type A:UINSTALL and press Enter.

$ The following screen appears.

+-------------------------------------------------------------------------

$ ¦ Installation Options

$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

$ ¦ Installation Source Drive

$ ¦

$ ¦ Enter the installation SOURCE drive letter, the drive that the program

$ ¦ installs FROM:

$ ¦

$ ¦ Source Drive ... [ A ]

$ ¦

$ ¦ Enter F1=Help F3=Exit

$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

$3. Press Enter twice.

$ The screen for selection appears.

$4. Using Down Arrow () or Up Arrow () select Install Hot Key Main

$ Program. Press Enter. Follow the instructions on the screen.

$5. Remove the backup copy of the Reference Diskette from the diskette

$ drive.

#6. Type:

# C:\L40SXUT\L40SXHK /MENU

# and press Enter. The menu for defining hot keys appears.

#7. Define hot keys for desired functions by following the instructions on

# the menu. Then press F10 to save your definitions.

PS/2 Model L40 SX Quick Reference

Installing the Hot Key Program for DOS

E.4.1 - 1

IBM L40 SX User Manual

Other manuals for IBM L40 SX