IBM L40 SX User Manual

#E.4.2 Installing the Hot Key Program for OS/2
#+--- To Use the Hot Key Utility -----------------------------------------+
¦ ¦
#¦ To use the hot key utility: ¦
¦ ¦
#¦  The power management device driver program for OS/2 must have been ¦
#¦ installed. ¦
#¦  The DOS compatibility box must have been configured. ¦
¦ ¦
#¦ For the power management device driver program for OS/2, see page ¦
#¦ D.1.1. ¦
¦ ¦
+------------------------------------------------------------------------+
#To install the program, follow the steps below.
$1. Insert the backup copy of the Reference Diskette into the diskette
$ drive.
$2. At the prompt on the DOS compatibility box, type A:UINSTALL and press
$ Enter.
$ The following screen appears.
+-------------------------------------------------------------------------
¦
$ ¦ Installation Options
¦
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
$ ¦ Installation Source Drive
$ ¦
$ ¦ Enter the installation SOURCE drive letter, the drive that the program
$ ¦ installs FROM:
$ ¦
$ ¦ Source Drive ... [ A ]
$ ¦
$ ¦ Enter F1=Help F3=Exit
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
¦
$3. Press Enter twice.
$ The screen for selection appears.
$4. Using Down Arrow () or Up Arrow () select Install Hot Key Main
$ Program. Press Enter. Follow the instructions on the screen.
$5. Return to the screen for selection. Using Down Arrow () or Up Arrow
$ () select Install Hot Key Program OS/2 Extension. Press Enter.
$ Follow the instructions on the screen.
$6. Remove the backup copy of the Reference Diskette from the diskette
$ drive.
$7. Press F3 to exit from the screen for selection.
$8. Type:
# C:\L40SXUT\L40SXHK /MENU
# and press Enter. The menu for defining hot keys appears.
#9. Define hot keys for desired functions by following the instructions on
# the menu. Then press F10 to save your definitions.
#10. Shut down then restart OS/2.
#Notes:
#1. Only the left Ctrl and left Alt keys are available.
#2. Do not define an alphabetic key as a hot key if it is already assigned
# a function by an application. Otherwise, pressing the key while
# holding down the left Ctrl and left Alt keys will perform both
# functions: first the function defined by the application, and then the
# function defined by the hot key program.
PS/2 Model L40 SX Quick Reference
Installing the Hot Key Program for OS/2
¦ Copyright IBM Corp. 1991
E.4.2 - 1

IBM L40 SX Specifications

General

Brand	IBM
Model	L40 SX
Category	Desktop
Language	English