IBM L40 SX - Page 80

3.8.4 Starting the Set Features Program with Commands
To change any of the operational features with commands, you first need to
|copy the Set features program from the backup copy of the Reference
|Diskette onto your hard disk or diskette.
If you have not done so, follow the instructions below, otherwise go to
"Commands" in topic 3.8.4.2 on how to use the command.
Subtopics
3.8.4.1 Copying the Set features program
3.8.4.2 Commands
3.8.4.3 Format
PS/2 Model L40 SX Quick Reference
Starting the Set Features Program with Commands
¦ Copyright IBM Corp. 1991
3.8.4 - 1