46
Introduction
This chapter contains the check procedures used to diagnose the causes of product failures. The diagnostic information consists of:
Start: This is the starting point for any diagnostic action. Based on high-level symptoms, the check procedure directs you to more detailed
procedures to help resolve machine failures.
Index of Symptoms, Messages, Error Codes, or Beeps: The tables for BIOS Error Messages, Codes, Beeps, and Error Symptoms list
symptoms along with their probable causes, and direct you to the applicable check procedures to help resolve machine failures. These
tables also list the field replaceable units (FRUs) most likely to cause a particular problem.
Check Procedures: When the Start check procedure or the Index of Symptoms, Messages, Error Codes, or Beeps tables point you to a
specific check procedure, proceed to that section. If there are any notes or instructions at the top of the page, read them before you begin
with the procedure. Carefully read each step of the check procedure and perform the steps as instructed. If you do not remember the
location of a specific part or test point, or an adjustment or removal procedure, see the chapter that contains that information. Always return
to the check procedure after you do this. In some cases, you are referred to other check procedures to detect the cause of the failure.
To Next Page
Loading...
Need help?
General
