90
Identifying the Parts of the System Unit
This computer system has 3 bays, each bay has a factory-installed drive in it. The devices are 3.5” Diskette, 40X CD-ROM drive and 10, 15
or 20 GB hard disk.
Diskette drives in this unit use the standard diskette advanced technology (AT) Interface. Hard disk and CD-ROM drives in this unit use an
integrated drive Electronics (IDE) AT interface. This computer supports the American National Standard Institute (ANSI) standard for AT
attachment disk drives and CD-ROMs.
This system has 3 interface cards slots for adapter card expansion. All of them are Peripheral Component Interconnect (PCI) interfaces.
This system has 1 video bridge expansion slot adjacent to the PCI slots. All models of this system will use a Lake Clark 2.4 card or
Ethernet card.
1. Power Supply
This is a 95-watt switching power supply.
2. Expansion slots
On the rear panel of the system unit are 3 slot openings for
installation of adapter card.
3. System board
4. CD-ROM Drive
This machine has a factory-installed 40 X CD-ROM drive 5. Hard Disk Drive
5. This machine has a factory-installed 10, 15 or 20 GB hard disk drive.
6. Diskette Drive
This machine has a factory-installed 3.5” 1.44MB floppy drive.
To Next Page
Loading...
