IBM Storwize V7000 2076-124 User Manual

As NTP is drift based, large time differences can prevent NTP from synchronizing,
or cause synchronization to take a long time. It can be helpful to synchronize time
manually once and to verify that the time is picked up correctly afterward. Use the
separate commands of service ntpd stop , ntpdate your IP, and service ntpd
start. The following example shows the sequence:
[root@domain.node ~]# service ntpd stop
Shutting down ntpd: [ OK ]
[root@domain.node ~]# ntpdate 9.19.0.220
14 Jan 12:06:46 ntpdate[25360]: adjust time server 9.19.0.220 offset 0.003277 sec
[root@domain.node ~]# service ntpd start
Starting ntpd: [ OK ]
[root@domain.node ~]#
After the time on all of the servers is synchronized, you can verify that the logs
apply to your troubleshooting situation.
172 Storwize V7000 Unified: Problem Determination Guide Version

IBM Storwize V7000 2076-124 Specifications

General

Model	2076-124
RAID Levels	0, 1, 5, 6, 10
Form Factor	2U
Drive Bays	24
Processor Cores	8
Operating Temperature	10°C to 35°C
Power Supply	Dual, Hot-swappable
Drive Interface	SAS
Host Interface	8 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Cache Memory	8GB