Need help?Do you have a question about the IBM Storwize V7000 Unified and is the answer not in the manual?
General| Model | IBM Storwize V7000 Unified |
|---|---|
| Storage Type | Unified Storage |
| RAID Levels | RAID 0, 1, 5, 6, 10 |
| Form Factor | 2U |
| Drive Types Supported | SAS, SSD |
| Maximum Drives | 504 |
| Network Protocols | iSCSI, FC, FCoE |
| Drive Bays | 24 per enclosure |
| Host Interface | 8 Gb FC, 1 Gb/10 Gb iSCSI |
| File Protocols | NFS, CIFS |
| Block Protocols | iSCSI, Fibre Channel |
| Type | Unified Storage |
| Maximum Host Ports | 16 |
| Operating System Support | VMware, Microsoft Windows, Linux, AIX |
| Data Services | Thin provisioning, replication |
| Power Supply | Redundant power supplies |
| Host Interfaces | 8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI |
Planning for Fibre Channel ports when adding file modules.
Planning for 1 Gbps Ethernet ports and IP addresses for file modules.
Define requirements before and during adding file modules.
Details compatibility between Storwize V7000 and file module software levels.
Safety and handling precautions for lifting and installing hardware.
Step-by-step guide for installing support rails for file module slides.
Instructions for installing file modules into the rack.
Steps to run the up2nas utility for initial setup of file modules.
To Next Page
