Gather information
Make sure you have IP addresses, system names, and other information needed in
order to properly initialize and set up your system.
You will need to have some information ready before you begin the initial setup of
your file modules, such as the IP addresses. Refer to “Information required before
initializing your system” on page 53.
You also need to have some information ready before you start the initial
configuration of your system using the management GUI. Refer to “Information
required before starting initial configuration of your system” on page 55.
ifs00010
File Module
File Module
Expansion Enclosure 8
Expansion Enclosure 6
Expansion Enclosure 4
Expansion Enclosure 2
Control Enclosure
Expansion Enclosure 1
Expansion Enclosure 3
Expansion Enclosure 5
Expansion Enclosure 7
Expansion Enclosure 9
Figure 22. Recommended rack locations
52 IBM Storwize V7000 Unified: Adding Storwize V7000 File Modules to an existing Storwize V7000 system 2073-720
To Next Page
Loading...
