IBM Storwize V7000 Unified User Manual

Table 36. The following IP address information is required before initializing your system. Fill
in all the information needed in the Value column before proceeding with this
installation. (continued)
Field Value Notes
Storwize V7000 Unified
management IP address
Your designated management
IP for the Storwize V7000
Unified system. This gives
access to the active
management node running
on a file module (such as
123.123.123.10)
File module 1 IP address The service access IP address
assigned to be assigned tofile
module 1 (such as
123.123.123.10)
File module 2 IP address The service access IP address
to be assigned to file module
2 (such as 123.123.123.11)
Note: The up2nas update checker utility will make sure that the new IP addresses
are not already in use somewhere else in your network.
Information required before starting initial configuration of
your system
About this task
You must enter specific information into the management GUI. These tables help
you record the key values needed before the initial set up and initial configuration.
Chapter 3. Before you begin adding file modules 55

IBM Storwize V7000 Unified Specifications

General

Model	IBM Storwize V7000 Unified
Storage Type	Unified Storage
RAID Levels	RAID 0, 1, 5, 6, 10
Form Factor	2U
Drive Types Supported	SAS, SSD
Maximum Drives	504
Network Protocols	iSCSI, FC, FCoE
Drive Bays	24 per enclosure
Host Interface	8 Gb FC, 1 Gb/10 Gb iSCSI
File Protocols	NFS, CIFS
Block Protocols	iSCSI, Fibre Channel
Type	Unified Storage
Maximum Host Ports	16
Operating System Support	VMware, Microsoft Windows, Linux, AIX
Data Services	Thin provisioning, replication
Power Supply	Redundant power supplies
Host Interfaces	8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI