Note: Make sure the top and the bottom of the power supply align with the
upper and lower tabs on the opening.
4. Install the screws that secure the power supply to the chassis.
5. Install the air duct.
6. Install the side cover (see “Installing the side cover” on page 49).
7. Stand the server back up in its vertical position.
8. Install the bezel (see “Installing the bezel” on page 49).
9. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Completing the installation
To complete the installation, you must reinstall the two-piece bezel, reinstall the side
cover, connect all the cables and, for some devices, run the Setup utility. Follow the
instructions in this section.
48 System x3100 M4 Type 2582: Installation and User's Guide
To Next Page
Loading...
