Installing the bezel
To install the bezel, complete the following steps:
1. Insert the three tabs on the bezel into the corresponding holes in the front of the
server.
2. Rotate the bezel to the server until it locks securely into place.
3. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Installing the side cover
Attention: For proper cooling and airflow, replace the side cover before turning on
the server. Operating the server for extended periods of time (more than 30
minutes) with the side cover removed might damage server components.
To install the side cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
2. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
3. Press on the side cover and push from the rear side of the side cover until it
locks securely into place.
Chapter 2. Installing optional devices 49
To Next Page
Loading...
