IBM System x3850 - Installing an Adapter; Installing the Remote Supervisor Adapter II Slimline; Installing a Serveraid-8 I

d. Close the tray levers and make sure they are securely latched.
e. Close the microprocessor-tray release latch.
f. Reinstall the fans and memory cards in the server.
If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 23.
Installing an adapter
The following describes how to install adapters in the server.
Installing the Remote Supervisor Adapter II SlimLine
The optional IBM Remote Supervisor Adapter II SlimLine must be installed in its
dedicated connector on the I/O board. The following illustration shows how to install
the Remote Supervisor Adapter II SlimLine.
I/O board
Remote Supervisor Adapter II SlimLine
Remote Supervisor Adapter II SlimLine connector
Standoff
Standoff
Complete the following steps to install a Remote Supervisor Adapter II SlimLine.
1. Insert the rear 1of the adapter into the rear standoff; then, rotate the front
2of the adapter into the front standoff.
2. Press the Remote Supervisor Adapter II SlimLine firmly into the connector.
Installing a ServeRAID-8i
If you are installing an optional ServeRAID-8i, review the following information:
v The ServeRAID-8i can be installed only in a dedicated slot on the PCI board.
v The ServeRAID-8i adapter is not cabled to the server and no rerouting of the
SAS cables is required.
20 IBM System x3850 Type 8864: Installation Guide