7
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
d. Connect the power cord to the power port on the back of your monitor
as shown in the illustration below.
e. Put the stand cover (e) back then put the cable cover (f) back.
4. Insert the plug into a properly grounded electrical outlet.
Turning on your Monitor
1. Turn on the power source and your computer.
2. To turn on your monitor, push and release the power switch marked .
To turn off your monitor, push and release the power switch again.
3. Turn on the monitor and then the computer.
4. To update or install device drivers, follow the instructions in the
Installing the Device Driver section on page 8.
5. To optimize the displayed image, run Image Setup by following the
instructions in the Automatic Image Setup section on page 11.
e
f
forward tilt
To Next Page
Loading...
Need help?
General
