Status Code ’11’
Status Text ‘Terminated by error XXXX ’
Probable Cause
The volume could not be processed because the
operation was terminated by a non-recoverable error
detected by the TS7700 prior to processing the
volume.
Status Code ’16’
Status Text 'Stacked Volume access failure’
Probable Cause
For Export, the logical volume could not be exported
because the TS7700 stacked volume containing the
logical volume is written in a pre-TS7700 format or
could not be accessed.
1. Check whether the physical volume is
written in the pre-TS7700 format using one
of the methods described in section Copy
Export Operation regarding pre-execution
checking. If the physical volume’s format is
not TS7700, the logical volumes must be
converted to the new TS7700 format.
2. On pre 8.5.x.x systems, refer to “Using
the Search Database for Volumes Window”
in the 3494 or 3953 Operator Guide. For
the volser indicated, if the Status Flags are
Inaccessible or Misplaced, follow
instructions in the “Problem Determination
with the Search Database for Volumes
Window” section of the operators guide.
3. On 8.5.x.x and higher systems, for the
volser indicated perform a Physical Volume
Search from the MI panel. Refer to the Info
Center for options with this panel.
4. If the volser Status Flags are other than
Inaccessible or Misplaced, call an IBM
Service Representative.
Status Code ’19’
Status Text ‘Logical Volume Copy Failure’
Probable Cause
The logical volume could not be exported because it
is currently resident in the tape volume cache and
attempts to copy it to a stacked volume failed.
Status Code ’1A’
Status Text ‘Logical Volume TVC State Unknown’
Probable Cause
The logical volume could not be exported because its
state in the Tape Volume Cache could not be
determined.
To Next Page
Loading...
Need help?
General
