August 15, 2017
© Copyright IBM Corporation, 2017 Page 69 of 117
• Requesting the TS7700 go online.
• Preparing the logical volume information to send to the Library Manager on pre 8.5.x.x systems.
• Loading recovered data into the active database.
• In progress.
If an error occurs during the copy export recovery process, the task detail window will indicate the reason.
The following table lists the possible error texts and the recommended action:
Volume XXXXXX is not known to the tape library.
1) Check that the physical volume is in the
library. Check that it had been moved to ‘Insert’
through the Unassigned Volumes panel on the
Library Manager.
2) Once you are sure that the volume is in the
library, retry the copy export recovery process.
Note: If you encountered this error because you
had not placed all of the source copy exported
physical volumes in to the library, in addition to
getting them into the library, you will need to
perform the Request Inventory Upload function
through the library manager
The mount of volume XXXXXX on device YYY
has failed.
1) Be sure the physical volume is available in the
library and that the physical tape device is
available and does not have an error.
2) Retry the copy export recovery process. If the
device continues to fail, mark it unavailable at
the Library Manager and retry the recovery
again. When retried, the TS7700 will select a
different available physical tape device
The database backup could not be read from the
specified recovery volume XXXXXX.
1) Check that the volume specified is indeed a
Copy Exported physical volume.
2) Retry the copy export recovery process. If a
retry also fails, retry using a different physical
volume.
The demount of the specified recovery volume
XXXXXX has failed.
Recovery will continue, but a call to IBM
support may be required to remove the physical
volume from the physical tape device.
The database backup image has been rejected by
DB2 and could not be restored.
Retry the copy export recovery process with a
different physical volume. If that also fails, call
IBM Support.
The database backup could not be restored.
Retry the copy export recovery process with a
different physical volume. If that also fails, call
To Next Page
Loading...
Need help?
General
