10
The DC Voltage is below the protection settings
and the battery protection mode is activated.
E1 Error Code
E1 Solutions
1. In case of using in the car, turn the car ignition
on and start the refrigerator again;
2. In the case of using the AC adapter to
connect the electricity at home, you can adjust
the battery protection to medium or low mode.
If it still does not start after adjusting the mode,
then the adapter is faulty and needs to be
replaced with a new one.
The cooling fan is over-loaded with more than
1A of current.
E2 Error Code
09
E1
Error Code
The DC Voltage is below the protection settings and
the battery protection mode is activated.
Solutions
1. In case of using in the car, turn the car ignition on
and start the refrigerator again;
2. In the case of using the AC adapter to connect the
electricity at AC socket, you can adjust the battery
protection to medium or low mode. If it still does not
start after adjusting the mode, then the adapter is
faulty and needs to be replaced with a new one.
E2
Error Code
The cooling fan is over-loaded with more than 1A of
current.
Solutions
If the fan does not start but the compressor does, this
is a short-circuited fan. You can x the error code by
replacing the fan.
To Next Page
Loading...
