Iceco APL20 - Page 13

11
If the fan does not start but the compressor does,
this is a short-circuited fan. You can x the error
code by replacing the fan.
E2 Solutions
Repeated switching of the machine or a faulty
input voltage causes this motor start error.The
pressure dierence in the refrigeration system is
too high.
E3 Error Code
1. Make sure to turn o the machine and wait
for 5 minutes before turning it on again. If the
compressor starts and then stops a few seconds
later, it is an E1 fault, and you need to refer to the
above E1 troubleshooting method for
troubleshooting;
E3 Solutions
10
E3
Error Code
Repeated switching of the machine or a faulty input
voltage causes this motor start error. The pressure
dierence in the refrigeration system is too high.
Solutions
1. Make sure to turn o the machine and wait for 5
minutes before turning it on again. If the compressor
starts and then stops a few seconds later, it is an E1
fault, and you need to refer to the above E1
troubleshooting method for troubleshooting;
2. The input voltage is too low to reach the minimum
starting voltage required by the battery protection,
resulting in the refrigerator can not start. Reduce the
starting voltage gear can solve the problem.