IceTech PR350H - Pinch Point Hazard; Wear Protective Gloves; How to Lift; Transport the Icemaker

Industrivej 62
DK-6740 Bramming
Denmark
Original
Version: 2.0
IceTech PR350H
User’s manual
Page:
9 of 20
Date: 2017.07.03
Init: JM
Pinch Point Hazard
If the plexiglass covers in front of the extruder plates are removed, the operator will be exposed to pinch point hazard.
Wear Protective Gloves
During work with the conveyor system, the operator must wear protective gloves in order to avoid contact with the dry
ice or with parts of the machine which are in direct contact with the dry ice.
How to Lift / Transport the IceMaker
1. The IceMaker is supplied with thread holes for lifting eyes. Always use lifting eyes to lift the IceMaker.
2. Always lift the IceMaker according to the lifting Instruction in this manual.
3. Lifting over persons and animals is prohibited.
4. Always use a forklift truck to transport the IceMaker.
5. Pick up the IceMaker from the side as shown in the drawings.
6. Transport the IceMaker upright.
7. Make sure that the forks are sufficiently long to fully engage the IceMaker.
8. Always check that the forks are adjusted to maximum width.