IceTech PR350H - Pour Point, ºC, ASTM D; Flash Point, ºC, ASTM D

ExxonMobil Lubricants & Specialties
All products may not be available locally. For more information, contact your local sales office or visit www.exxonmobil.com.
ExxonMobil is comprised of numerous affiliates and subsidiari
es, many with names that include Esso, Mobil, or ExxonMobil. Nothing in this document is intended to override or
supersede the corporate separateness of local entities. Responsibility for local action and accountability remains with the local ExxonMobil-affiliate entities. Due to continual
product research and development, the information contained herein is subject to change without notification. Typical Properties may vary slightly.
© 2001 Exxon Mobil Corporation. All rights reserved.
Mobil
DTE FM
32
Mobil
DTE FM
46
Mobil
DTE FM
68
Mobil
DTE FM
100
Mobil
DTE FM
150
Mobil
DTE FM
220
Mobil
DTE FM
320
Mobil
DTE FM
460
Mobil
DTE FM
680
15.6º
C/15.6º C,
ASTM D
4.52
Copper
Strip
Corrosion,
ASTM D
130
1A 1A 1A 1A 1A 1A 1A 1A 1A
Rust
Characteri
stics Proc.
A, ASTM
D 665
Pass Pass Pass Pass Pass Pass Pass Pass Pass
Pour
Point, ºC,
ASTM D
97
-12 -9 -12 -18 -12 -21 -30 -36 -39
Flash
Point, ºC,
ASTM D
92
212 226 228 246 250 246 272 284 278
FZG, DIN
51354,
Fail Stage
11 12+ 12+ 12+ 12+ 12+ 12+ 12+ 12+
4-Ball
wear,
ASTM D
4172,
Scar Dia,
20Kg, 54º
C, 1800
rpm, 1 hr,
mm
0.25 0.25 0.25 0.25 0.26 0.25 0.25 0.30 0.30
Health & Safety
Based on available information, this product is not expected to produce adverse effects on health when used for the intended
application and the recommendations provided in the Material Safety Data Sheet (MSDS) are followed. MSDS's are available upon
request through your sales contract office, or via the Internet. This product should not be used for purposes other than its intended use.
If disposing of used product, take care to protect the environment.
The Mobil logotype, the Pegasus design and Delvac are trademarks of ExxonMobil Corporation, or one of its subsidiaries.