Industrivej 62
DK-6740 Bramming
Denmark
Version: 2.0
IceTech PR350H
User’s manual
Date: 2017.07.03
Init: JM
SAFETY OPERATION
Emergency stop
All equipment is connected to the general emergency system for IceTech PR350H.
When an emergency-stop device is activated, all components located in the emergency zone will be disconnected from
their power source.
Machine safety
There are machine safety measures in the following areas:
• Extruder unit
• Extruder plate changer
In these areas, the protection is established with covers.
The covers is provided with locking screws, so that it can only open when using proper tools.
Required performance level PLr = c Implemented in category = Cat3.
There is danger of congelation / frost bites by touching machine parts cooled down by dry ice.
To prevent congelation the entire machine enclosure is provided with locks and requires special tools to open.
To Next Page
Loading...