Procedures for maintenance and repair
www.icetechworld.com | IceTech Dry Ice Technology | Rev 1
Page 58
Procedure no. 14 Changing hydraulic oil hydraulic station.
Procedure step by step
1. Remove the oil. Drain out off this ball valve pos. 1. The used oil must be deposited at
an approved station for environmental waste.
2. Clean the hydraulic tank pos. 2 inside by removing the cover plate pos. 3 on the tank
side.
3. Reassemble the hydraulic tank.
4. Unscrew the air filter (see picture below) and fill
DTE MOBIL FM
46 IceTech Art.Nr.4F0221
. Approved for food manufacturing” in the
hydraulic tank.
Notice: If there are no demand for oil approved for food manufacturing, this oil can be used
instead DTE MOBIL 10 Excel
46 IceTech Art.Nr.4F0220
. See hydraulic oil specifications in
section 8 datasheets.
Recommended oil volume:
PR750H 260 Litres DTE MOBIL FM
46 or DTE MOBIL 10 Excel 46.
PR350H 220 Litres DTE MOBIL FM 46 or DTE MOBIL 10 Excel 46.
SL1000H 250 Litres DTE MOBIL FM 46 or DTE MOBIL 10 Excel 46.
Hydraulicoilcan
befilledinhere.
To Next Page