Icom GM1600 21K - OPTIONAL ACCESSORIES; Swivel Belt Clip (MB-86)

21
OPTIONAL SWIVEL BELT CLIP
8
■ MB-86 contents
Qty.
Belt clip ………………………………………………………… 1
Base clip ……………………………………………………… 1
Supplied screws ……………………………………………… 2
■ Attachment
q Screw the base clip to the back of the transceiver using
the two screws (supplied) as shown below.
w Clip the belt clip over your belt and insert the transceiver.
e Once the transceiver is locked in place, it swivels as illus-
trated below.
■ Detachment
➥ Turn the transceiver upside down in the direction of the
arrow and pull out from the belt clip.
Supplied screws
R CAUTION!
HOLD THE TRANSCEIVER TIGHTLY, WHEN HANGING
OR DETACHING THE TRANSCEIVER FROM THE BELT
CLIP.
Otherwise the transceiver may not be attached to the belt
clip or swivelled properly attached to the belt clip and may
not swivel properly. The transceiver could then be acciden-
tally dropped and scratched or damaged .