Icom IC-A200 User Manual

—e
ol
i Frequency selection
methods
There are 2 ways to select a desired frequency.
General frequency selection
Select a desired frequency which is used for the next
operating frequency in the STBY window. Then, ex-
change the USE window frequency for the STBY window
frequency.
Refer to STBY window frequency selection at right and
frequency exchanging. (p. 4)
Direct frequency selection
Select a desired frequency in the USE window directly.
Refer to USE window frequency selection. (p. 4)
CONVENIENT: For quick frequency selection, often-
used frequencies can be programmed into memory
channels. Refer to memory operation. (pgs. 7~10)
When a memory channel is recalled, the previous STBY
window frequency is erased.
FREQUENCY SELECTION
i STBY window frequency
selection
CAUTION: DO NOT tum the power ON until the
aircraft engines have been started. This is important for
protection of the circuits.
1) Rotate the volume control clockwise to turn the power
ON.
« Previously used frequencies appear in the USE and
STBY windows.
2) Rotate the large and small tuning knobs to select a
desired frequency.
The USE window frequency is not affected.
«To change the 1 MHz digit, use the large tuning
knob. The small tuning knob does not change the
1 MHz digit.
1 MHz steps. 50 kHz steps
25 kHz steps
when pushed IN.
when pulled OUT.

Icom IC-A200 Specifications

General

Brand	Icom
Model	IC-A200
Category	Transceiver
Language	English