To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...How to fix Icom IC-A25N that does not turn on?
If your Icom Transceiver does not turn on, there could be a few reasons. First, the battery might be exhausted, in which case you should recharge it. Second, the battery pack may not be correctly attached; try reattaching it properly. Lastly, if you are using the CP-20, its fuse might be blown. If so, repair the underlying problem and then replace the fuse.
Why Icom Transceiver will not transmit?
If you cannot transmit with your Icom Transceiver, ensure that you have selected a COM band frequency, as you cannot transmit on a weather channel or VOR frequency. Also, check if the battery is exhausted and recharge it if necessary.
What to do if Icom IC-A25N Transceiver keypad is locked?
If your Icom Transceiver displays “Locked” when you push keypad keys or rotate [DIAL], the keypad and [DIAL] are likely locked. To unlock them, push [F], and then push [ ].
Why scan does not start on Icom IC-A25N Transceiver?
If the scan function does not start on your Icom Transceiver, it may be because all memory channels in the selected group are not tagged. To resolve this, tag memory channels on the Menu screen.
How to turn on beep sound on Icom IC-A25N Transceiver?
If you are not hearing any beep sounds on your Icom Transceiver, the beep output level may be set to OFF. Adjust the beep output level on the Menu screen by going to [MENU] > Sounds Settings > Beep.
General| Display type | LCD |
|---|---|
| Display diagonal | 2.3 \ |
| Backlight display | Yes |
| Battery type | BP-288 |
| Battery life (max) | 10.5 h |
| Number of batteries supported | 1 |
| Product color | Black, Grey |
| International Protection (IP) code | IP57 |
| Operating temperature (T-T) | -10 - 60 °C |
| Antenna connector type | BNC |
| Purpose | Aviation Service (Air Band) |
| Maximum range | - m |
| Operating frequency | 108 - 163.275 MHz |
Weight and Dimensions| Depth | 31.8 mm |
|---|---|
| Width | 58.9 mm |
| Height | 148.4 mm |
| Weight | 340 g |
Identifies and explains the function of each key, button, and connector on the transceiver's exterior.
Instructions on how to charge the battery pack using the supplied charger and power adapter.
Covers setting frequency, receiving signals, adjusting squelch, using ANL, and transmitting.
Step-by-step guide on navigating to a VOR station using the transceiver's display.
Guide on selecting waypoints from memory, flight plan, history, or manual entry.
Instructions for navigating a pre-defined flight plan and its sequential waypoints.
How to start, stop, and control the scanning direction of the transceiver's receiver.
Steps to edit existing memory channels, including name, type, frequency, and group.
How to set and use the Priority Watch function to monitor a specific channel.
Technical details including frequency range, power, dimensions, and receiver sensitivity.
Table listing common problems, their possible causes, and recommended solutions.
