Why can't I change the operating frequency on my Icom IC-A6E?
If you are unable to change the operating frequency or memory channel on your Icom Transceiver, the lock function may be activated. To deactivate it, push, then push [7• ].
What to do if Icom Transceiver operating frequency cannot be changed?
If you cannot change the operating frequency or memory channel on your Icom Transceiver, it's likely that the lock function is activated. To deactivate it, push, then push [7• ].
How to fix an Icom IC-A6E when no power comes on?
If your Icom Transceiver isn't powering on, there are several potential causes. First, the battery may be exhausted, so try recharging it. Second, there may be a bad connection with the battery pack, so check the connection to the transceiver. Finally, the CP-20’s fuse may be blown; in this case, identify the cause and replace the fuse.
Why is there no sound coming from the speaker of my Icom Transceiver?
If you're not hearing any sound from your Icom Transceiver's speaker, it could be due to a couple of reasons. The squelch level might be set too deep; try adjusting the squelch to the threshold point. Alternatively, the volume level might be too low; adjust the [VOL] to a suitable level.
What to do if my Icom Transceiver is not transmitting?
If your Icom Transceiver is not transmitting, there are two possible reasons. You may have the NAV band selected, if so, set COM band in frequency mode. Alternatively, the battery may be exhausted, so recharge the battery pack.
What to do if the scan does not start on my Icom IC-A6E?
If the scan function on your Icom Transceiver isn't starting, consider these potential causes: 1. Ensure that all memory channels in the selected bank are programmed as “TAG” channels, and if not, set the “TAG” settings of desired channels. 2. If the squelch is open, set the squelch level to tighten it. 3. If there are less than two memorized channels, program two or more memory channels.
How to turn on beep sounds on Icom IC-A6E?
If you are not hearing any beep sounds on your Icom Transceiver, the beep tones may be turned OFF. To turn them back on, push, then push [8•BEEP], and rotate [DIAL] to adjust the beep tone level.
Why Icom IC-A6E won't turn on?
Your Icom Transceiver might not be turning on due to several reasons. First, the battery might be exhausted, in which case you should recharge the battery pack. Another possibility is a bad connection for the battery pack; check the connection to the transceiver to ensure it's properly connected. Lastly, if you're using the CP-20, its fuse might be blown. Check for the cause and replace the fuse with a new one.
General| Battery Life | Up to 12 hours |
|---|---|
| Weight | Approx. 240 g |
| Dimensions | 58 x 130 x 36 mm |
| Power Supply Requirement | 7.2 V DC |
| Antenna Impedance | 50 Ω |
| Output Power | 5W / 1W |
| Mode | AM |
| Channel Capacity | 200 channels |
| Channel Spacing | 25 kHz |
| Modulation System | AM |
| Spurious Emissions | -60 dB or better |
| Adjacent Channel Power | > 70 dB |
| Voltage | 7.2 V DC |
| Frequency Range | 118.000 - 136.9916 MHz |
| Audio Output Power | 0.5 W |
To Next Page
